First Aid Kits for Tradies: What to Carry on Site and in the Ute

A good tradesman first aid kit covers the injuries your trade actually produces: cuts, splinters, burns, sprains, eye injuries and the odd serious bleed. It is built from WorkSafe’s sample list, then topped up for your hazards. It stays where you can reach it in seconds, whether that is the site shed or a secured spot in the vehicle. This guide shows what to put in, how to adjust it for your trade, and how to keep it in working order.

Safewell
Get a First Aid Kit for Your Trade
Safewell supplies first aid kits and medical supplies tailored to workplaces, helping tradies prepare for the hazards of their work.
Explore first aid supplies

TL;DR

  • New Zealand law requires adequate first aid equipment, but it does not prescribe a kit list. WorkSafe’s guide says contents should be based on your work risks and gives sample contents.
  • Start with WorkSafe’s sample work kit (dressings, bandages, tape, saline, gloves, CPR mask), then add for your hazards, such as eye pads, eyewash or burn dressings.
  • Mobile and lone tradespeople need a portable kit secured in the vehicle, plus a plan for getting help.
  • Check the kit at least every 12 months, replace used or expired items, and make sure everyone knows where it is.
  • A kit is not a substitute for first aid training or for controlling the hazards in the first place.

Table of Contents

What the law expects of a tradie or contractor

If you employ people or run a business, you are a PCBU (person conducting a business or undertaking). Under regulation 13 of the General Risk and Workplace Management Regulations 2016, you must provide adequate first aid equipment, make sure each worker can reach it, and make sure workers can reach first aid facilities. You must also make sure enough workers are trained in first aid, or that workers can reach enough other trained people. The regulation says to consider the nature of the work, the hazards, the size and location of the workplace and the number and makeup of the workforce. A breach is an offence, with fines of up to $10,000 for an individual and $50,000 for anyone else.

There is no legally fixed kit list. WorkSafe’s first aid at work guide says to provide at least one kit for each workplace and make sure workers know where it is. Kits should handle cuts, scratches, punctures, grazes and splinters, soft tissue sprains and strains, minor burns, broken bones, eye injuries and shock.

Two other points matter for tradies:

  • You cannot charge workers for it. WorkSafe’s first aid page says a PCBU must not impose a levy or charge on a worker for anything provided for health and safety, including first aid kits.
  • On a shared site, WorkSafe’s general risk guidance says PCBUs can coordinate and share first aid resources. Do not assume the head contractor’s kit covers your crew. Agree it in writing before the job starts.

In an emergency, phone 111. First aid is the immediate care given until a doctor or emergency services take over. WorkSafe is clear that it does not replace assessing work risks and eliminating or minimising them.

For a wider view of obligations, see our guide to workplace first aid compliance in NZ.

The baseline: what goes in a tradie’s first aid kit

The best starting point is the sample work first aid kit in WorkSafe’s guide (Figure 1 in the first aid at work document). It is a sample, not a legal minimum, but it is the reference most NZ workplace kits are built around.

Item Sample quantity What it is for
First aid and CPR instructions 1 Guidance when you are under stress
Non-adherent dressing/pad, 7.5 x 10cm 3 Medium wounds, grazes
Non-adherent dressing/pad, 10 x 10cm 1 Larger wounds
Non-adherent dressing/pad, 5 x 5cm 6 Small cuts and punctures
Non-stretch hypoallergenic tape, 2.5cm 1 roll Holding dressings
Conforming cotton bandage, 7.5cm 3 Securing dressings, light compression
Conforming cotton bandage, 5cm 3 Fingers, hands, wrists
Safety pins At least 6 Fastening slings and bandages
Tweezers 1 Splinters, debris
Scissors 1 Cutting dressings, tape, clothing
Resuscitation mask or face shield 1 Rescue breaths during CPR
Disposable nitrile gloves 2 pairs Protecting you and the patient
Adhesive dressing strips Pack of 50 Minor cuts
Saline, 15ml 8 Flushing wounds and eyes
Triangular bandage 2 Slings, securing limbs
Cetrimide 1% wound cleaning wipes 10 singles Cleaning around wounds

A few notes on using this list well:

  • Gloves matter more on site. Dirt, dust and other people’s blood are a normal part of a messy injury. Many tradies add extra pairs.
  • Dressings go first. On a building site, bleeding from cuts and punctures is the most likely emergency. Do not let the plasters crowd out the larger pads and bandages.
  • Label and protect it. WorkSafe says a kit can be any size or shape, but it should be clearly labelled “First Aid Kit” (most use a white cross on green). It should also carry a contents list and be made of material that protects the contents from dust, moisture and contamination. A tool-bag pocket full of loose plasters does not meet that description.

Some kits also add dental emergency supplies, which can suit trades where flying fragments or falls are a concern. Treat these as an optional extra on top of the baseline.

If you want a ready-made option, our workplace first aid kits come in soft packs sized for different crew numbers, including the 1-5 person kit for small crews.

The baseline: what goes in a tradie's first aid kit

Matching the kit to your trade’s hazards

WorkSafe says contents should reflect the particular risks of the work. When working out what is adequate, its general risk guidance tells you to consider the injuries that have occurred or could reasonably be expected, where equipment can be placed so it is prominent and accessible, and whether you need equipment beyond kits. Its example of additional equipment is an AED where there is a risk of electrocution. It also tells you to consider the distance to medical treatment, the hours of work, and how workers are spread across the site. It suggests asking workers what they think they need.

So walk your own site and ask: what could realistically happen here? The table below is a practical way to think about it. The hazards come from common trade work, and the add-ons are suggestions to consider, not a legal list.

If your work involves Injuries to prepare for Consider adding
Grinders, saws, power tools Deep cuts, crush injuries, severe bleeding Extra large dressings, extra bandages, spare gloves
Welding, cutting, machining, abrasive blasting Eye injuries, burns Eye pads, eyewash, burn dressings
Chemicals, paints, solvents, open containers Splashes to eyes and skin Eyewash, extra saline
Hot tar, hot surfaces, hot work Burns Large sterile burn dressing
Work at height Falls, fractures, sprains Extra triangular bandages, rescue blanket
Electrical work Shock, burns AED nearby, burn dressings
Heavy lifting, manual handling Strains and sprains Crepe bandages
Outdoor work in sun, cold or heat Exposure Rescue blanket, water, sun protection

WorkSafe says eye pads may be needed where there is a higher risk of eye injury. That includes handling chemical liquids or powders in open containers, spraying, hosing or abrasive blasting, flying particles, infectious material splashes, and welding, cutting or machining. If your trade appears on that list, do not rely on a standard kit alone.

A free first aid risk assessment template from Duress lists hazards such as machinery, hazardous chemicals, hot work, falls, vehicles, electrical work, manual handling, violence, lone work and extreme weather. It also notes that specific hazards call for specific equipment, such as eyewash where chemicals are used.

How many kits do you need?

One kit per workplace is the floor, not the target. WorkSafe’s Appendix B worked example shows a site with an office and a factory floor that ends up with five kits (one in the office, four on the factory floor), plus eyewash. Kits should be reachable ideally within minutes, one in each separate work area, with locations shown on site maps or emergency floor plans.

For a tradie, that usually means:

  1. a kit on site in a marked, known spot (not buried in a ute canopy),
  2. a kit in each work vehicle,
  3. extra supplies where the specific hazard happens, such as eyewash beside the cutting bench.

As a rough guide to sizing, our 1-15 person kit and 1-25 person kit suit larger crews, and a 1-50 person kit suits a bigger yard or depot.

Lone workers, mobile trades and remote jobs

Many tradespeople work alone, move between sites, or work well outside the reach of a quick ambulance. WorkSafe’s first aid at work guide has specific rules for these situations.

Vehicles. If the vehicle is the workplace, you must provide a portable first aid kit in it. It must sit in a secure place where it will not move and cause injury or damage in a collision. That rules out sliding around on the tray or the back seat.

Remote or isolated work. You must provide a basic kit and extra first aid equipment if required. WorkSafe’s Figure 2 lists extra contents for these kits, which compared with the standard sample include:

  • a large sterile burn dressing,
  • a 10cm crepe bandage,
  • a torch,
  • a whistle,
  • a rescue blanket,
  • two large non-adherent dressings instead of one.

You must also provide a plan for how remote workers will get help if hurt or ill.

Moving between sites. Where the location varies, as it does for tradespeople, and no first aider is present, you still have to make sure workers can access first aid and know how to reach first aiders. WorkSafe’s guidance suggests control measures such as making sure workers can contact first aiders or emergency services, and requiring them to carry the location details and phone numbers of the nearest medical centre or hospital.

In practice, a lone tradie should be able to answer these before leaving the yard:

  • Is the kit in the vehicle, secured, and complete?
  • Does someone know where I am working today and when I should check in?
  • Do I have phone coverage, and what is my fallback if I do not?
  • Do I know the nearest medical centre or hospital to this address?

If you work in roadside or road works, WorkSafe’s worker facilities guidance adds that kits may be carried in work vehicles for mobile work. It also says you may need an extreme conditions kit in some situations.

Compact options for the ute

Our lone worker and vehicle first aid kits are designed for people working on their own or from a vehicle. If a pouch that fits the glovebox suits you, the economy lone worker kit in a soft pouch is one place to start. If you want more contents and a bigger bag, there is also the premium lone worker kit in a large soft pack.

Get your kit sorted with Safewell

We supply first aid kits, refill supplies, spill management, safety items and medical equipment to workplaces, homes and community organisations across New Zealand, with delivery nationwide. Our range covers full kits and individual consumables, so you can buy a ready-made kit for the crew and the ute, then restock only the items you have used.

First Aid Kit Premium Lone Worker In Large Soft Pack Bag

Browse our first aid kits for workplaces and industry, or see everything we stock on the full categories page. If you need a vehicle kit refilled, our envelope-style lone worker refill restocks the contents without replacing the whole kit.

Keeping the kit ready: checks, restocking and access

A kit with expired or missing items is a false comfort. WorkSafe’s guide sets out good practice:

  • Nominate someone to maintain the kits, perhaps a first aider.
  • Monitor use and replace items as soon as practicable.
  • Check at least every 12 months that the kit is complete, with an inventory list signed and dated after each check.
  • Check items work, are within expiry dates, and that sterile products are still sealed.

For busy trades, 12 months is the minimum. The Duress template suggests a restock check at least quarterly with one named owner, which suits a kit that gets knocked around in a vehicle. A quick monthly glance at the ute kit is a sensible habit, especially after any incident.

WorkSafe’s road and roadside guidance also says kits should be kept up to date, checked regularly, and have missing or expired items replaced. All workers should be given clear information about first aid at their workplace. That means:

  • where the kits are, including in work vehicles,
  • who the first aiders are and where to find them,
  • where a first aid room is, if there is one,
  • what to do when someone needs first aid.

Put this in the site induction or toolbox talk. Tell every new apprentice and subcontractor on day one, because a kit nobody can find does not count as provision.

Training goes with the kit

A kit is only useful in trained hands. WorkSafe’s first aid page says you must ensure enough workers are trained, or that workers can access other trained people. It also says it is good practice for a worker to be trained in CPR.

When deciding how many first aiders you need, consider:

  • the number of workers and whether they are spread out,
  • the type of work, its risks, and how likely and how severe injuries could be,
  • the size and location of the workplace,
  • distance from emergency services and medical facilities,
  • other people at the workplace,
  • cover for leave or resignations.

WorkSafe’s road repair example shows how this plays out. A company facing machinery, hot tar, dust, busy public roads and remote sites decides to have at least two first aiders at each worksite for every 10 workers. Your own number will come from your own assessment, but the reasoning is the same.

FAQ

Is there a legally required tradesman first aid kit in NZ?

No single kit is prescribed by law. You must provide adequate first aid equipment based on your work, hazards, workplace and workforce. WorkSafe’s guide offers sample contents as a reference, and you adjust from there.

What should I add to a standard kit for welding or cutting work?

WorkSafe says eye pads may be needed where there is higher risk of eye injury, including welding, cutting, machining, abrasive blasting and flying particles. It is also worth considering eyewash and burn dressings near hot work. Base the final list on your own risk assessment.

Where should the first aid kit go in my ute?

It should be in a secure place in the vehicle where it will not move and cause injury or damage in a collision. It should also be easy to reach quickly, and everyone using the vehicle should know where it is.

How often should I check my kit?

WorkSafe says check at least every 12 months, signing and dating an inventory list each time. Replace used and expired items as soon as practicable. Many tradies check more often, since vehicle kits take a battering.

Can I make my employees pay for their own first aid kit?

No. WorkSafe says a PCBU must not charge a worker for anything provided in relation to health and safety, which includes first aid kits and facilities.

Sources

This article was produced with AI assistance and reviewed for accuracy. It is provided for general information only and is not professional advice.